![Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump() Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump()](https://blog.honzamrazek.cz/wp-content/uploads/2022/01/failures-1024x562.jpg)
Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump()
Phrozen 3D Printer - It is important to allow enough time for the resin to stabilize before the UV lights turn on. This would ideally be around 2-3s. | Facebook
![Lift/retract speed at 90mm/min, light off delay 1.5s support density circa 70%, 2.5 exposure 7mm lift height. I dare you to try and work out why these won't print on 3 separate Lift/retract speed at 90mm/min, light off delay 1.5s support density circa 70%, 2.5 exposure 7mm lift height. I dare you to try and work out why these won't print on 3 separate](https://preview.redd.it/lift-retract-speed-at-90mm-min-light-off-delay-1-5s-support-v0-6tjw6k6uw2e91.jpg?width=640&crop=smart&auto=webp&s=6326dca1ea215a51b443e7ecbb2ad1dbeba4726a)
Lift/retract speed at 90mm/min, light off delay 1.5s support density circa 70%, 2.5 exposure 7mm lift height. I dare you to try and work out why these won't print on 3 separate
![A Step-by-step Guide for the Perfect Bed Adhesion and Removing Elephant Foot on a Resin 3D Printer – mind.dump() A Step-by-step Guide for the Perfect Bed Adhesion and Removing Elephant Foot on a Resin 3D Printer – mind.dump()](https://blog.honzamrazek.cz/wp-content/uploads/2022/02/intro.jpg)